Fiber cable installation is not an easy task for most of us. It’s thought as the job of professional engineers since special training is needed during the complicated process. But it would be better if you know knowledge of fiber cable installation in case that you need to run fiber cable in your home or business. This article is going to offer you some tips for fiber cable installation.
Before Fiber Cable Installation
Before starting fiber cable installation, please make sure there is fiber optic service in your area. If it’s available, find the nearest distribution box. What you need to do is to run fiber cable from the box to your house.
A considerate plan is the first step of successful fiber cable installation. Carefully design the cabling route. It would be better if you mark where the cable goes, into the walls, or underground, or through conduit... Point out all the termination points and splice points. At the same time, write down any potential problems you may come across during the installation. A good plan is also beneficial to avoid fiber cable waste.
Once finish the plan, you’re going to buy fiber optic cable for your applications. Except fiber optic cable, you need tools for cable management & installation, fiber splicing and fiber testing. So make a shopping list for your fiber cable installation. Then select a reliable fiber cable supplier who can meet the requirements of both high quality and low cost.
During Fiber Cable Installation
What You Should Do
Leave spare cable length—Each fiber cable for installation should be a few inches longer than the plan says. Because you can’t make sure everything goes as you wish. So you should leave plenty of spare fiber cables when beginning cable installation work.
Avoid electrical interference—Though fiber cable is not as vulnerable to electrical noise as copper cables, some devices, such as the boxes for fluorescent lights, may cause interference. So keep your fiber cable three or more feet from those devices.
Avoid end face contamination—The tip of fiber optic connector can be easily contaminated or damaged. So leave protective caps on until you are ready to plug into the equipment. Don’t forget to inspecting the end face before plugging in. If there is any contaminate, clean it.
Fiber network testing—Test each section of your fiber optic network. That’s easy to discover the problem and troubleshoot it. Don’t do this work until you finish the entire cable installation. In that situation, it’s hard to find out the trouble if the network fails.
What You Should Not Do
Don’t bend fiber cables. Fiber optic cables perform the best when it is running straight. But during installation in reality, sometimes bending can’t be avoided. Cables from different vendors may have different standards of bend radius. Or you can buy bend insensitive fiber cable for better performance.
Don’t pull too hard on the cable. Properly pull the fiber cable to avoid bending or snagging through the conduit or underground. However, don’t pull it too hard especially when the fiber cable is too short. Otherwise, it would ruin the cable or fiber optic connector.
Don’t mix and match different core sizes. Fiber optic cables are typically color coded. From the outside cable jacket, you can get information about fiber core sizes. To know more about fiber cable jacket, you can visit my last blog What Can We Get From Fiber Cable Jacket?
Don’t pinch the fiber cable. Pinch the fiber cable can squeeze the fiber and affect link performance. When use zip-ties, pay attention to this point.
Conclusion
Once you finish fiber cable installation, you can enjoy fiber optic network. See, fiber cable installation is not as tough as you think. Follow these tips mentioned above when you run cables for your house, you can keep away from most bothering issues.
Originally published at www.fiber-optic-equipment.com
No comments:
Post a Comment